Show HN: I turned my iPhone and a $20 smart plug into an f-stop timer
52 points - today at 1:58 PM
I am a film photographer and do some darkroom printing and always wanted one of the proper, advanced f-stop timers, but never really wanted to spend a couple hundred dollars on one. Eventually I figured my phone was already perfectly capable of doing the timing, it just needed a way to switch the enlarger.
So I built Darkplug around a cheap smart plug. The app controls the enlarger over the local network and does regular timing, f-stop timing, test strips, has an intuitive dodge/burn workflow, split grade (2 timing channels) and paper development timing.
I’ve been using it for a few months in my improvised bathroom darkroom.
Fair warning: the app was blindly vibe coded using Codex and Xcode.
Comments
I always assumed, probably incorrectly, that there would be too much jitter in the actual timing so I had built a few prototypes of e.g. an esp8266 controlled relay, where you would give the MCU a duration rather than separate on/off commands. But I guess that was wildly over-optimizing. In your case, how stable is the delay from the app sending a command until the switch operates?
I'd add voice mode for color printing in total darkness.